what is the best method of cutting a loaded standard ?
1. transfer the load before hand ?
2, cut loaded standard and let the load go in to beam and then into a standard already carrying a load, using a disk cutter or tube cutter ?
3, insert a extra standard with a screw jack . tighten it up to take the tension. remove the attached members to the standard to be removed.
knock out the sole board and then cut the standard.
4. can you not cut a standard with a load in it ?
advice would be most welcome
many thanks
1. transfer the load before hand ?
2, cut loaded standard and let the load go in to beam and then into a standard already carrying a load, using a disk cutter or tube cutter ?
3, insert a extra standard with a screw jack . tighten it up to take the tension. remove the attached members to the standard to be removed.
knock out the sole board and then cut the standard.
4. can you not cut a standard with a load in it ?
advice would be most welcome
many thanks