Can anyone tell me what the allowable tolerance is on a standard and ledger to be out of level.
I cant find it in TG20 anywhere.
Cheers
Grunt
As per BS 5973:1993 Table 4 — Erection tolerances
Feature Erection tolerances
Standards Vertical to within ± 20 mm in 2 m
(Subject to max. deviation of 50 mm)
well if you get over give us a shout i will be in abu dhabi
---------- Post added at 11:47 PM ---------- Previous post was at 11:43 PM ----------
i was wondering if anyone could tell me - what the safe working loads are on the legs if you have a independent 10 lifts high based on 2m lift heights and what the safe working loads are on the ledgers - in the tg20 when talks about axle loads is this for the ledgers?