Is there enough trannys in that boss?

I wish you wouldn't call them trannies... :D, especially in that boss!
 
Is that a barcode or transoms. Holy Mary

Sent from my GT-I9300 using Tapatalk 2
 
A few years ago we did a loading bay with the lifts at 2.7m floor levels.

When we got the design done it had 3 sets of beams on each lift and the trannies where 4 inches apart.
 
3 less than i put in my loading bays 8 standards use to be 6 standards and 8 trannys :laugh:
 
Looks very similar to what I have to put up, got a telling off yesterday for not putting 20 transoms in one of the loading bays :(
 
Old firm I was on had a similar design that barrats sent out to hold six tonne but stil only alowed 2 packs of bricks on it so wat was the point
 
the loading bays we have to do are the same but with 25 trannys 25 punch up for next lift 4 standards but this is how the trannys are laid green red and blue all trannys green 1's ither end irght on the board ender and the next red 3 are were the band is about 2/3 inch appart then the same next to all the standards and in between 3 trannys splitting the diffrence plan braced ledger braces sway fornt back takes about an hour to lift them lol


loading bays.jpg
 
You must log in or register to reply here.
Top Bottom