harsco trade test for offshore . holland

[dertboll]

hi guys,

any suggestions most welcome .

thankyou

 

[Havespannerwilltravel]

Always keep the wedges to the outside of standards and obviously always narrow end downwards!. Very simple fittings to use just use some common sense. Good luck!

 

[VancouverLeedsLondonBoy]

And if you drive a wedge in so that you can't smash it back up from underneath then hit the clamp on the side or top left or right to make it pop up again

 

[VancouverLeedsLondonBoy]

I mean really really go to town with the hammer otherwise you'll look a bit daft when you can't get it out

 

[happyhugenoet]

get yer arse doon to lidls they have the system hammer thats a wee bit like a slaters with the long spike,ideal for the wedges

you could always refuse to wqork with the turks and poles

 

[Havespannerwilltravel]

And if you drive a wedge in so that you can't smash it back up from underneath then hit the clamp on the side or top left or right to make it pop up again

If you put a wedge in that can't be knocked up from underneath you have done it wrong and will fail.

 

[dertboll]

anyone got a picture of these type of fittings, been googling with no joy ffs. want to be going in there loaded up and prepared.

 

[Havespannerwilltravel]

Take a look at van thiel. They can also be seen if you google At-PAC and look at products